How To Repair Water Toys

1. Drain the remaining water in the pool, open the gas valve to release the gas in the edge air chamber, and facilitate the cleaning of the pool body later.
2. Cut out a patch. It is best to be 3 times the size of the damaged area, and it is recommended to trim it into a circle.
3. Do primer treatment. Clean the repair area and patch, apply special glue evenly, and use a hair dryer or natural air drying until it does not stick to your hands.
4. Do glue repair treatment. Apply the glue again to the area where you just applied the glue, and do the same until it is non-sticky.
5. Align the patch with the patch area, slowly fit the patch, and flatten it. It should be noted that air bubbles should be avoided when pasting, otherwise the paste will not be firm.
6. Finally, put the pool body on the flat ground and press it with a heavy object for 24 hours.